![so you have to use lms 332c power nmea 2000 network so you have to use lms 332c power nmea 2000 network](https://s3.manualzz.com/store/data/029053160_1-6167563e7e63570d2f4017b6496d0ee4.png)
However, the unit will not work until the wires are attached correctly. No damage will occur if the power wires are reversed. This unit has reverse polarity protection. This will protect both the unit and the power cable in the event of a short. When the unit is turned off but still connecįor example, if you have to extend the power cable to the power bus or battery, attach one end of the fuse holder directly to the power bus or battery. Caution: We strongly recommend that you shut off the power supply to the power cable when the unit is not in use, especially in saltwater en- vironments.
SO YOU HAVE TO USE LMS 332C POWER NMEA 2000 NETWORK INSTALL
If this results in electrical interference, connect direct to a battery but install an in-line switch on the cable. Attach the display power cable (with provided 3-amp fuse) to an accessory switch or power bus. Powering Your Display Unit The display unit works from a 12-volt DC battery system.
![so you have to use lms 332c power nmea 2000 network so you have to use lms 332c power nmea 2000 network](https://data2.manualslib.com/first-image/i2/10/966/96574/lowrance-lms-332c.jpg)
It is labeled "NMEA 2000 POWER." The branch with four wires (blue, yellow, orange, and shield) is a data cable, labeled "RS-232 COMM." It supp The thinner branch with three wires (red, black and shield) is the power cable for a NMEA 2000 network. The thicker three-wire cable (white, red and black) is the power supply for your display unit. Power Connections Your unit comes with a power/data cable that splits into three branches, each with several exposed wires. The segment covering changes in installation procedur
![so you have to use lms 332c power nmea 2000 network so you have to use lms 332c power nmea 2000 network](http://www.mrmarine.com.au/nmea207.jpg)
Your unit now packs with a 2-foot (61 cm) blue-to-red adapter cable, 15- foot (4.6 m) extension cable, LGC-3000 GPS module, double T connector and two 120-ohm terminators. 988-0151-182 Addendum I LMS-480M, LMS-480DF & ® GlobalMap 4800M This addendum addresses new items packed with your unit, changes to ® installation procedures, and NMEA 2000 upgrades not documented in the LMS 480M, LMS-480cDF and GlobalMap 4800M manuals.